10
February 2020
Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
Machine Description
Section 2: Machine Description
2.7 Options Label
A label depicting all possible options is always provided with the base SCE300 actuator. If a
module(s) is installed after the actuator has been delivered, the local operator must mark
the label to show that the relevant module(s) were installed.
Figure 4
Options Label
S/N:
OM1OM3 OM9
OM11 OM13
Figure 5
Ensure that the label is applied in the area shown in the picture below.
To Next Page
Loading...
