Emerson Bettis SCE300 - Electrical Connections

18
February 2020
Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
Installation
Section 4: Installation
4.7 Electrical Connections
Before powering the actuator, check that the supply voltage details on the nameplate
are correct for the plant. Access to terminals for electrical connections is through the
terminal cover.
WARNING
Installation, conguration, commissioning, maintenance, and repairs must be performed by
approved and qualied personnel only.
WARNING
When performing maintenance or conguration on a powered-on actuator, beware of the
potential electrical hazard. Use the correct tools and carefully follow the instructions in
this manual.
NOTICE
When removing the cover assembly or terminal block cover on existing installations, follow
the safety rules applicable to the site.
NOTICE
All accessories (including cable glands) must comply with the approved specications for
the site requirements and be certied according to the standard directive.