October 2015
Service Instructions
VA001-196-30 Rev. 1
9
Section 2: Actuator Disassembly
Actuator Disassembly
NOTE:
The M3 jackscrew (1-70) will be removed from the inside of housing (1-10).
2�3�8 Actuator models CBB420/520/525/725 with a M3 or M3HW mounted in the
outboard end of housing (1-10) complete steps 2.3.8.1 and 2.3.8.2.
2�3�8�1 Remove retainer ring (2-40) from M3 adapter (1-90).
2�3�8�2 Remove M3 adapter (1-90) from housing (1-10).
NOTE:
The M3 adapter will be removed from the inside of housing (1-10) with the M3 jackscrew (1-70).
To Next Page
Loading...
