Emerson BETTIS E796 2000 M2CP - 1.7 Long Term Storage

Installation and Maintenance
Part Number: E2K-402-0313, Rev. A
Mar 2013
3
Section 1: Introduction
Introduction
4. BETTIS supplies plugs in each conduit entry. Do not remove until electrical
hook-up.
5. Cover units loosely with a plastic sheet. This serves as partial protection from rain.
1.7 Long Term Storage (Stored more than one year
from shipment)
1. Store indoors or MCP must be removed and stored in protected area. Follow
procedures of short term storage.
WARNING:
FAILURE TO STORE ACTUATOR PROPERLY WILL VOID WARRANTY OF ELECTRICAL &
ELECTRONIC COMPONENTS
2. Don’t torque seat valve, sluice gate or damper unless the valve manufacturer
recommends.