12
ETL Model No.: CF788
4. How to Hang Your Ceiling Fan (Continued)
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
NOTE: CEILING COVER, SUPPLY WIRES AND FAN WIRES
OMITTED FOR CLARITY.
HANGER BRACKET
HANGER BALL
HANGER BALL
GROOVE
ANTI-ROTATION
TAB
Figure 18
4.3
Carefully lift the partially assembled Ceiling Fan
and seat the Hanger Ball/Downrod Assembly on the
Hanger Bracket that was just attached to the Outlet Box
(Figure 18).
Be sure the Groove in the Ball is engaged with the
Anti-rotation Tab on the Hanger Bracket (Figure 18).
NOTE: Be very careful not to bend the blade
assemblies while hanging the partially assembled
ceiling fan.
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
WARNING
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING
!
Hanger bracket must seat firmly against outlet box.
If the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
WARNING
!
To Next Page
Loading...
