16
ETL Model No.: CF788
WALL CONTROL
CODE SWITCHES
ON
1
23
4
5I
CODE
SWITCHES
WALL
CONTROL
Figure 25
Setting Operating Frequency of
Wall Control
7.3
Your Wall Control has Code Switches which must
be set in one of 32 possible Code Combinations
(Figure 25). The Five Levers (numbered 1, 2, 3, 4,
and 5) on the Switch are factory-set in the ON (up)
position. Change the Switch Settings as follows:
Slide the Five Switch Levers in the Wall Control to your
choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the Levers firmly up
or down.
The Sixth Switch marked ON and I is for Dimming
Control of Lights: Set Switch to ON to allow for
Dimming of the Lights. Set Switch to I for No Dimming
of the Lights.
7. Wall Control Procedures
General
7.1
Your Emerson Ceiling Fan/Light Control consists of
Wall Mounted Transmitter and a Receiver which is
mounted under the Fan Ceiling Cover. The Remote
Control is designed to separately control your Ceiling
Fan Speed and Light Intensity.
Code Switches in the Transmitter and Receiver may
be set in 32 different positions. If your Fan and Light
go ON and OFF without using your Control, you
may be getting interference from other Remote units
such as garage door openers, car alarms or security
systems. To remedy this situations, simply change the
Combination Code in your Transmitter and Receiver.
Preset Memory Feature
7.2
Your Emerson Receiver is equipped with a Preset
Memory Feature. If the AC Supply to the Receiver
is powered through a Wall Switch, when the Switch
is turned OFF, the Control will remember the Light
Intensity and Fan Speed. When the Switch is turned
back ON, the Light and Fan will resume operation as
they were prior to the Switch being turned OFF.
To Next Page
Loading...
