13
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF430
6. Final Assembly (continued)
6.8
All fans are shipped from the factory with the reversing
switch positioned to circulate air downward.
6.9
If airflow is desired in the opposite direction, turn the
fan off and wait for the blades to stop turning.
Then slide the reversing switch, located on top of the
fan motor assembly, to the opposite position
(Figure 18) and turn the fan on again. The blades will
turn in the opposite direction and reverse the airflow.
Reverse Switch Information
Season Rotation Direction Switch Position
Summer Counter-Clockwise Right
Winter Clockwise Left
REVERSING
SWITCH
Figure 18
Please call Emerson technical support at
1-800-654-3545 if you have any questions
about installation and operation of this ceiling fan.
KNURLED KNOBS (2)
LOCKWASHERS (2)
THREADED
STUDS (2)
CEILING
COVER
Figure 17
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
WARNING
!
6.6
Lift the ceiling cover up to the threaded studs and turn
until studs protrude through the holes in the ceiling
cover (Figure 17).
6.7
Secure the ceiling cover in place by sliding lockwashers
over the threaded studs and installing the two knurled
knobs (supplied). (Figure 17). Tighten the knurled
knobs securely until the ceiling cover fits snugly against
the ceiling and the hole in the ceiling cover is clear of
the downrod.
BP7486 CF430 Highrise OM 12/13/13 10:35 AM Page 13
To Next Page
Loading...
