Emerson FB1100 - Page 13

FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide
D301820X012
November 2020
11
Tip
If you have more than one terminal block to replace, we recommend you replace one
terminal block at a time to avoid confusion.
1. Remove the rear end cap by first removing the retaining clamp on the end cap (if present)
using a 3 mm hexagonal wrench.
Components of Retaining Clamp Assembly (front clamp shown) Rear End Cap
1
Screw
2
Retaining Clamp
3
Washer
2. Grasp the end cap.
Rear End Cap
3. Unscrew the end cap turning it counter-clockwise until the cover comes off. Set it aside in
a safe location.