Need help?Do you have a question about the Emerson Micro Motion FDM and is the answer not in the manual?
General| Manufacturer | Emerson |
|---|---|
| Product Line | Micro Motion |
| Model | FDM |
| Hazardous Area Approvals | ATEX, IECEx, FM, CSA |
| Wetted Materials | Hastelloy |
| Output | 4-20 mA HART, FOUNDATION Fieldbus |
| Power Supply | 24 VDC |
| Process Connection | Threaded, Flanged |
Provides information on planning, mounting, and wiring the FDM.
Lists other documents for more product information.
Verifies shipment contents, safety, environment, and equipment for installation.
Offers tips for handling, verification, storage, and operation for optimal meter performance.
Details the DC power specifications for operating the meter.
Distortion in wave forms caused by pipe wall reflections, leading to inaccuracy.
Maintain constant flow rates within specified limits for meter performance.
Minimizing entrained gas for accurate and reliable fluid measurement.
Ensuring quality measurement when solids are present by managing fluid velocity.
Minimizing temperature gradients and using insulation for fluid accuracy.
Ensuring pressure and temperature limits for meter connections are not exceeded.
Details three standard installations to alleviate onsite calibration needs.
Procedure to check the meter for damage and verify calibration before installation.
Guidelines for mounting the meter in a free-stream flow.
Mounting the meter in a free-stream application using a flanged fitting.
Mounting the meter in a free-stream application using pipe expanders.
Mounting the meter in a free-stream application using a weldolet fitting.
Guidelines for mounting the meter in T-piece configurations.
Mounting the meter in a 2-inch T-piece using a flanged fitting.
Mounting the meter in a 3-inch T-piece using a flanged fitting.
Mounting the meter in a T-piece using a weldolet fitting.
Guidelines for installing the meter using a flow-through chamber.
Procedure for mounting the long-stem meter in an open tank.
Procedure for mounting the long-stem meter in a closed tank.
Instructions for attaching the PFA ring and circlip to the meter flange.
How to rotate the transmitter electronics for optimal viewing.
Steps to rotate the transmitter display module for better visibility.
Details available wiring terminals and general requirements for transmitter outputs.
Procedures for wiring analog, TPS, or discrete outputs in hazardous or non-hazardous areas.
Connects the processor to the remote-mount 2700 fieldbus transmitter using 4-wire cables.
Wiring up to three external HART devices to the meter.
Wiring meters with TPS output to signal converters or flow computers.
Outlines grounding practices, including standards and guidelines for sensor grounding.
To Next Page