Instruction Manual
D104239X012
Multiport Flow Selector
January 2019
21
Introduction
The Multi-Port Actuator is a Bettis single turn actuator for control of multi-port flow selectors (MPFS) with 3 to 8 ports.
A typical application is oil or gas well selection for well production testing as shown in figure 1. Typically the MPA is the
actuator of a Multi-Port Flow Selector as shown in figure 2. There are applications in other processes where control of
multi-port valves is required.
Figure 1. Typical Well Test Application
WELL 1
WELL 2
WELL 3
WELL 4
WELL 5
WELL 6
WELL 7
TO TEST SEPARATOR
TO PRODUCTION
WELL 1
WELL 2
WELL 3
WELL 4
WELL 5
WELL 6
WELL 7
TO TEST SEPARATOR
TO PRODUCTION
To Next Page
Loading...
