Emerson Liebert GXT4-3000RT230 - Liebert GXT4 UPS Installation Guide; Unpacking and Inspecting the Liebert GXT4

6 Chapter 2 Installation
Liebert GXT4 UPS 700VA ~ 3000VA (230V) User Manual
Chapter 2 Installation
This chapter expounds the installation of the UPS, including unpacking and inspection, included items, preparation for
installation, mechanical installation and cable connection.
2.1 Unpacking And Inspection
Unpack the UPS and conduct the following checks:
1. Inspect the UPS for shipping damage. If any shipping damage is found, report it to the carrier and your local dealer
or your Emerson representative immediately.
2. Check the accessories included in packaging list. If there is any discrepancy, contact your local dealer or your
Emerson representative immediately.
2.2 What’s Included
With GXT4 UPS:
 Compact disk with: Liebert MultiLink, Configuration Program, User Manual
 Terminal Block Communication terminals
 USB cable: one, 6-1/2 ft. (2m) long
 RS232 cable: one, 6-1/2 ft. (2m) long
 Mounting hardware: including screws, two handles and a pair of slide rails
 Plastic tower stand sets: 2 (four pieces)
 Line buckle: 2 pieces
 The anti-skid rubber cushion and instructions
 Safety Instructions
 GXT4 2000-3000RT230 will ship with the following items included in the box:
A (1) Schucko to IEC-320-C19 input cords
B (1) UK to IEC-320-C19 input cords
C (1) Australian type A to SAA Input cords (except Europe model without Bundle rack slide kit)
 For models 700VA – 1500VA 230V models will ship with the following items included in the box:
A (1) Australian type A to SAA Input cords (except Europe model without Bundle rack slide kit)
 GXT4 500-1500VA will ship with (2) 10A IEC C13 C14 Output Cable 2m
 GXT4 2000-3000VA will ship with (3) 10A IEC C13 C14 Output Cable 2m
 Note
1. The Liebert GXT4 external battery cabinet shipping package includes one battery cabinet, two spacers for tower installation
and one DC power cable.
2. The RS232 cable is exclusively used for Liebert GXT4 UPS.
2.3 Preparation For Installation
2.3.1 Installation Environment
1. Install the UPS indoors in a controlled environment, where it cannot be accidentally turned off. The installation
environment should meet the specifications listed in Chapter 9 Specifications.