What to do if my Emerson Liebert GXT MT+LB 10KL has Fault 1A?
If your Emerson UPS indicates Fault 1A, it means the UPS output power is negative, indicating energy feedback into the UPS from the output. This may be due to a regenerative load or current control failure in a parallel system. Contact the dealer.
What to do if my Emerson Liebert GXT MT+LB 10KL UPS has high internal temperature (Warning 0D)?
If the internal temperature of your Emerson UPS is too high, ensure the ambient temperature is not over 40°C, the fan is working correctly, and ventilation is unobstructed. If possible, remove some loads.
What to do if my Emerson Liebert GXT MT+LB 10KL UPS is locked in bypass after overload (Warning 33)?
If your Emerson UPS is locked in bypass after an overload, remove excess loads from the UPS output. Then, shut down the UPS and restart it.
What to do if my Emerson Liebert GXT MT+LB 10KL shows Warning 08?
If your Emerson UPS displays Warning 08, it could be due to several reasons: the battery is deeply discharged, the battery number is incorrect, or the battery is at the end of its life. Try these steps: 1. Recharge the battery. 2. Correct the battery number. 3. Replace the battery.
What to do if Emerson UPS output has a short circuit (Fault 14)?
If a short circuit occurs on the Emerson UPS output, remove the short-circuited component or correct the situation that caused it. If the problem persists, contact the dealer for repair.
What to do if my Emerson Liebert GXT MT+LB 10KL has Fault 13?
If your Emerson UPS displays Fault 13, it indicates that the internal inverter has failed, causing the inverter voltage to be too low. Contact the dealer for repair.
What to do if my Emerson UPS has Fault 11?
If your Emerson UPS displays Fault 11, it indicates that the internal inverter has failed, preventing the inverter voltage from starting up correctly. Contact the dealer for repair.
What to do if my Emerson Liebert GXT MT+LB 10KL UPS has Fault 12?
If your Emerson UPS displays Fault 12, it indicates that the internal inverter has failed, causing the inverter voltage to be too high. Contact the dealer for repair.
What to do if my Emerson UPS has Fault 02?
If your Emerson UPS shows Fault 02, it could be due to the mains input or load transient current causing the DC bus voltage to be too high, or the internal converter has failed. Shut down and restart the UPS to see if it happens again. If the problem still persists, please contact the dealer for repair.
What to do if my Emerson Liebert GXT MT+LB 10KL UPS displays Warning 10?
If your Emerson UPS displays Warning 10, it means the input fuse on the power stage board is blown. Check and replace the input fuse.
Key operational safety guidelines, including earth conductor, live parts, and foreign objects.
Crucial safety instructions and requirements for installing the UPS system correctly.
Step-by-step guide for installing a single UPS unit, including wiring and safety precautions.
Details on the function of each button on the UPS control panel.
Describes the different audible alarms, their causes, and buzzer status.
Step-by-step guide for operating a single UPS unit with utility power and connecting devices.
Describes warning indicators, fault codes, and how to interpret them.
Explanation of the UPS's LED indicators and the LCD panel layout.
Explains fault indications, causes, and immediate actions for critical errors.
Details common UPS warnings, their codes, possible causes, and recommended remedies.
Details common UPS faults, their codes, possible causes, and recommended remedies.
Important safety precautions and general guidelines for UPS maintenance by qualified personnel.
To Next Page
General