Important Safety Precautions 
Warning 
Observe all cautions and warnings in this manual. Failure to do so may result in serious injury or death.   
Refer all UPS and battery service to properly trained and qualified service personnel. Do not attempt to service 
this product yourself.   
Opening or removing the cover may expose you to lethal voltages within this unit even when it is apparently not 
operating and the input wiring is disconnected from the electrical source. Never work alone. 
Save These Instructions 
This manual contains important safety instructions that must be followed during the installation and maintenance 
of the UPS and batteries. Read this manual thoroughly before attempting to install or operate this UPS. 
UPS Safety Notes 
This UPS contains no user-serviceable parts except the internal battery pack. Do not continue to use the UPS if 
the front panel indications are not in accordance with these operating instructions or if the UPS performance 
alters in use. Refer all faults to your local dealer, Emerson Network Power representative or Emerson Network 
Power Channel Support. 
This UPS has an internal battery, and the output receptacles of the UPS may carry live voltage even if the UPS 
is not connected to utility input power.   
Before moving or rewiring this UPS, disconnect utility input power and the battery and make sure that the UPS is 
completely shut down. Otherwise, the output terminal may carry live voltage, presenting an electric shock 
hazard. 
To ensure human safety and normal UPS operation, the UPS must be properly grounded before use. When the 
UPS is connected to an IT power distribution system, a short-circuit protection device must be installed on the 
neutral line. 
Install and use the Liebert GXT4 UPS in the following environments: 
 Temperature: 32°F ~ 104°F (0°C ~ 40°C), relative humidity: 0% ~ 95% non-condensing   
 Out of direct sunlight   
 Away from heat sources   
 Stable surface, not subject to vibrations or shocks   
 Away from dust and other particulates   
 Away from corrosive substances, salts and flammable gases   
Keep the air inlet and outlet of this UPS unobstructed. Poor ventilation will increase the internal temperature of 
the UPS and can adversely affect the UPS and its batteries. 
Keep liquid and foreign objects away from the UPS. 
In case of fire, use a dry chemical fire extinguisher to put out the fire. Using a fluid fire extinguisher may cause 
electric shock. 
This UPS is not intended for use with life support and other designated critical devices. Maximum load must not 
exceed that shown on the UPS rating label. This UPS is designed for data processing equipment. If uncertain, 
consult your local dealer or Emerson representative.