Emerson MICRO MOTION 1500 - Page 170

Connection to transmitter terminalsFigure A-5:
A
B
C
A. Computer
B. Signal converter
C. Transmitter
Note
This figure shows a serial port connection. USB connections are also supported.
3. To connect over the RS-485 network:
a. Attach the leads from the signal converter to any point on the network.
Connection over networkFigure A-6:
D
C
A
B
E
A. Computer
B. Signal converter
C. 120-
Ω , 1/2‐watt resistors at both ends of the segment, if necessary
D. DCS or PLC
E. Transmitter
Note
This figure shows a serial port connection. USB connections are also supported.
4. Start ProLink III.
5. Choose Connect to Physical Device.
Using ProLink III with the transmitter
164 Micro Motion Model 1500 Transmitters with Analog Outputs