Emerson MICRO MOTION 1500 - Trimming the Milliamp Output

Configuration and Use Manual 3
Before You Begin
Using ProLink II Required ConfigurationFlowmeter StartupBefore You Begin
1.7 Pre-configuration worksheet
Item Configuration data
Sensor type

T- S e r i e s

Other
Installation type

4-wire remote

Remote core processor with remote transmitter
Transmitter software
version ______________________________________
Core processor type

Standard

Enhanced
Core processor software
version
______________________________________
Outputs Channel A (Terminals 21 & 22) Milliamp
Channel B (Terminals 23 & 24) Discrete output

Internal power

External power
Channel C (Terminals 31 & 32)

Discrete output

Discrete input

Internal power

External power
Assignment Channel A (Terminals 21 & 22)

Process variable ____________________

Primary valve control

Secondary valve control

3-position analog valve control
Channel B (Terminals 23 & 24)
______________________________________

Active high

Active low
Channel C (Terminals 31 & 32)
______________________________________

Active high

Active low
Measurement units Mass flow
______________________________________
Volume flow
______________________________________
Density
______________________________________
Pressure
______________________________________
Temperature
______________________________________
ProLink II version
______________________________________