Need help?Do you have a question about the Emerson Micro Motion Elite Coriolis CMF200 and is the answer not in the manual?
General| Measurement Principle | Coriolis |
|---|---|
| Communication Protocol | HART, Modbus, FOUNDATION Fieldbus, Profibus PA |
| Accessory Type | Flow Meter |
| Process Connection | Flanged, Threaded, Sanitary |
| Output Signal | 4-20 mA |
| Application | Liquid and gas measurement |
| Material | Stainless steel |
Steps to ensure proper installation of the Micro Motion sensor and transmitter.
Guidelines for optimizing sensor performance and installation quality.
Specifies acceptable ambient and process temperature ranges for sensor operation.
Guidance for installing sensors in hygienic and self-draining process applications.
Safety and procedural advice for safely handling and lifting heavy sensor units.
Instructions on how to properly mount the sensor, considering torque and bending load.
Procedure for rotating the junction box or core processor for optimal positioning.
Guidance on mounting electronics separately for high-temperature sensor applications.
Instructions for mounting a CMF010 sensor using an optional wall or pole configuration.
Steps for mounting CMFS007, CMFS010, or CMFS015 sensors using a bracket.
Procedure for mounting CMFS025, CMFS040, or CMFS050 sensors with a wall mount bracket.
How to secure wafer-style sensors using the provided installation kit and alignment rings.
Instructions for attaching extended electronics to the sensor case using an extender.
Overview of different wiring procedures based on the electronics option installed.
Detailed steps for preparing and connecting a 4-wire cable for sensor and transmitter communication.
Procedure for preparing and connecting a 9-wire cable for sensor and transmitter communication.
Procedure for purging the sensor case with inert gas to remove oxygen and moisture.
Information about the rupture disk installed on the sensor case for process fluid venting.
To Next Page