Need help?Do you have a question about the Emerson Micro Motion Elite Coriolis CMFS100 and is the answer not in the manual?
General| Type | Coriolis Flow Meter |
|---|---|
| Model | CMFS100 |
| Measurement Principle | Coriolis |
| Fluid Types | Liquid, Gas |
| Category | Accessories |
| Manufacturer | Emerson |
| Output Signal | 4-20 mA, HART |
| Accessory Type | Flow Meter |
| Application | Process measurement and control in industries such as oil & gas, chemical, food & beverage, pharmaceutical, and water & wastewater |
| Compatibility | Emerson Micro Motion Transmitters |
| Product Line | Micro Motion |
| Pressure Range | Up to 1000 psig (69 bar) |
Checklist for verifying environmental suitability and proper installation parameters.
Guidelines to optimize sensor performance and ensure correct installation procedures.
Defines the permissible ambient and process temperature ranges for sensor operation.
Recommendations for installing sensors in hygienic systems for optimal cleanability and drainage.
Procedures and equipment recommendations for safely lifting and positioning heavy meter units.
Instructions for installing the sensor, focusing on minimizing torque and bending load on connections.
Procedure for rotating the integrally mounted junction box or core processor in 45-degree increments.
Steps for mounting electronics of high-temperature sensors separately from the sensor case via flexible conduit.
Optional mounting configuration for CMF010 sensors for use with small or flexible pipelines.
Procedure for using an optional mounting bracket for CMFS007, CMFS010, or CMFS015 sensors.
Instructions for mounting CMFS025, CMFS040, and CMFS050 sensors using an optional wall mount bracket.
Guide on securing wafer-style sensors into the pipeline using a wafer installation kit and alignment rings.
Procedure for attaching an extender to the sensor case for installations with extended electronics.
Explains wiring procedures based on the specific electronics option installed on the sensor.
Detailed guidance on preparing and connecting 4-wire cables for power and signal transmission.
Instructions for preparing and connecting 9-wire cables between the sensor and transmitter or core processor.
Procedure for purging the sensor case with inert gas to remove oxygen and seal it.
Information regarding the rupture disk installed on the sensor case for venting process fluid in case of tube breach.
To Next Page