16 PACSystems™ RSTi-EP EPSCPE115 Standalone CPU Quick Start Guide GFK-3039C
• Ethernet cable for connecting the PME programmer computer to the CPE115.
• Very small slotted screwdriver (2 mm blade jeweler’s size) for securing wires to
the connector.
Basic Installation Steps:
For start-up and configuration of the CPE115, complete the following steps:
1) Be sure to disconnect the power to CPE115.
2) Mount the unit as described in Installation & Mounting
3) The ESCPE115 is designed to be DIN-rail-mounted.
4) Plug the Ethernet cable for Programmer & Protocol (SRTP, Modbus, EGD) into
the LAN 1 port.
5) Plug the Ethernet cable for the PROFINET network into a LAN 2 port.
6) Apply power to CPE115.
To Next Page
Loading...
