3 PACSystems™ RSTi-EP EPSCPE115 Standalone CPU Quick Start Guide GFK-3039C
Membrane Run/Stop Pushbutton
The Membrane Run/Stop push button is located at the
bottom right of the front panel (see Figure 1). Pressing
it briefly, will change the state of CPU from the current
state to the next state. It acts as a toggle switch, as
shown in the following state diagram:
Note: The Run/Stop
switch is enabled by
default; it can be
disabled in PME
Hardware
Configuration (HWC)
settings.
LED Indicators (LEDs)
Ethernet Status Indicators
For each port of LAN1 and LAN2, there are two LEDs (Yellow/Green) embedded in the
RJ-45 connectors. The green LED indicates an Ethernet connection has been
established on that port. The yellow LED indicates packet traffic on that port.
Figure 1: Run/Stop
Pushbutton
To Next Page
Loading...
