Emerson PACSystems RSTi-EP - Ethernet Ports

5 PACSystems™ RSTi-EP EPSCPE115 Standalone CPU Quick Start Guide GFK-3039C
LED
LED State
Operating State (after Power-Up)
Blinking; All
other LEDs
off
Indicates that PLC has encountered a fatal error and is
blinking the error code.
Fault
On Red
PLC is in STOP/Faulted mode: a fatal fault has occurred.
Refer to Troubleshooting FAQs for more details.
Off
No fatal faults detected.
Ethernet Ports
CPE115 provides two independent Fast Ethernet LANs.
• LAN1 has only one port and is dedicated to the embedded Ethernet controller.
• LAN2 is comprised of 3 switched ports, each configurable either as a second
embedded Ethernet controller or as an embedded PROFINET controller.
Use PME to configure the operation of the ports.
All the Ethernet ports of both the LAN1 and LAN2 are capable of automatically sensing
the link data rate (10 Mbps or 100 Mbps), communications mode (half-duplex or full-
duplex), and cabling arrangement (straight-through or crossover).
To establish Ethernet communications between the PME programming software and
the CPE115, you first need to set a valid IP address.
CPE115
LAN1
LAN2
Default IP Address:
192.168.0.100
0.0.0.0
Subnet Mask:
255.255.255.0
0.0.0.0
Gateway:
0.0.0.0
0.0.0.0