Emerson PACSystems RX3i PROFINET - Functional Compatibility

GFK-2573Z Sep 2020
10
Functional Compatibility
The following CPU firmware and programming software versions are required to use the features introduced in
PNC001 release 2.00 and later:
Subject
Feature
Minimum Version Required
RX3i backplane
hardware
RX3i backplane hardware
The following minimum backplane hardware revision must be
used:
IC695CHS012-BAMP
IC695CHS016-BAMP
IC695CHS012CA-BAMP
IC695CHS016CA-BAMP
or
IC695CHS012-CA (or later)
IC695CHS016-CA (or later)
IC695CHS012CA-CA (or later)
IC695CHS016CA-CA (or later)
or
IC695CHS007-AA (or later)
When installing, operating, or maintaining the IC695PNC001,
personnel must ensure any electrostatic charge is discharged
through the use of a grounded ESD strap or other means.
PLC CPU Firmware
Version Requirements
RX3i PNC001-Bxxx Release
3.00
New Hardware & Firmware to
Resolve Component
Obsolesence
CPE330 Release 8.95
CPU320/CPU315 Release 8.95
CPE310/CPE305 Release 8.95
CRU320 Release 8.95
CPE302 Release 9.40
(Other CPU models are not supported)
RX3i PNC001 Release 2.26
Support Remote Get HART
Device Information
COMMREQ
CPE330 Release 8.95
CPU320/CPU315 Release 8.95
CPE310/CPE305 Release 8.95
CRU320 Release 8.95
CPE302 Release 9.40
(Other CPU models are not supported)
Extended PROFINET device
Subslot Number range
CPE330 Release 8.70
CPU320/CPU315 Release 8.70
CPE310/CPE305 Release 8.70
CRU320 Release 8.70
CPE302 Release 9.40
(Other CPU models are not supported)
RX3i PNC001 Release 2.20
HART Pass Through
CPE330 Release 8.50
CPU320/CPU315 Release 8.50
CPE310/CPE305 Release 8.50
CRU320 Release 8.50
CPE302 Release 9.40
(Other CPU models are not supported)