Quick Start Guide Section 1
GFK-2941K Sep 2019
User Features 3
• Achilles Level 2 Communications Certification
1
.
• Supports secure firmware update. The controller authenticates new firmware
prior to installation and continues to use the current version if non-authentic
firmware is detected.
• Embedded SNTP Client allows synchronization of the high-resolution Time of Day
Clock to an SNTP network time server.
• Optional Energy Pack, IC695ACC402, allows CPE330 to instantly save user
memory to non-volatile storage in the event of loss of power.
• Ability to transfer user programs and/or data to and from USB 2.0 A type
Removable Data Storage Devices (RDSDs).
• HART Pass Through allows the CPE330 to communicate HART asset management
data between HART-capable I/O modules and PC-based asset management tools.
(Requires additional HART-compatible products.)
• Supports the Remote Get HART Device Information COMMREQ, which allows the
user application to read information from a HART device connected to an RX3i
Analog module in an IC695PNS001 RX3i PROFINET Scanner. A UDFB that
automates the COMMREQ control logic is available for download from the Emerson
support website. (Refer to New Features and Enhancements for additional
information.)
• Sequence of Events recording is available through the Embedded PROFINET
Controller when used with up to four IC695PNS101 Advanced PROFINET Scanner
modules. A RX3i SoE system supports events from up to 512 SoE input points with
a system storage buffer for up to 128,000 events at a maximum rate of 400 events
per second per PNS101. Each PNS101 supports SoE recording with IRIG B time
synchronization of events accurate to 1ms and buffers up to 4000 events from up
to four IC694MDL660 32 Circuit Discrete Input modules. Unmodulated IRIG B time
Achilles Level 2 Communications Certification available in CPE330 R8.80
To Next Page
Loading...
Need help?
General
