PARTS AND FEATURES
Dry mode
Press the "mode" button until the Dry mode indicator is lit. The screen displays the room temperature. At the same time,
the "low" fan indicator will light up.
Note: In this mode, fan speed cannot be selected.
Fan mode
Press the "mode" button until the Fan mode indicator is lit.
In this mode, you can select fan speed "hi", "med", "low", or "auto".
The screen displays room temperature.
Note: In this mode, the air exhaust hose does not need to be connected.
ECO mode
Press the "mode" button until the EC0 mode indicator is lit.
Press the Fan speed button to select fan speed; the fan speed indicator will be lit. You can choose a setting in the
following sequence: HI, MED, LOW, AUTO.
Press the "▼" or "▲" button to select desired temperature.
A few seconds after you set the temperature, the screen will display the room temperature.
Note: The unit will run in energy saver (ECO) mode when used for the first time. In this mode, the fan will continue to run
for 3 minutes after the compressor shuts off. The fan then cycles on for 90 seconds at 10-minute intervals until the room
temperature is above the set temperature, at which time the compressor turns back on.
To Next Page
Loading...
Need help?
General
