Frame Lock, Sash Lock, and Foam Seal Installation
Tools Needed:
Phillips Screwdriver
Drill (if plot holes are needed)
1. Place the frame lock between the extended accordion panels
and the window sill as show in FIG. 9. Screw a 3/4" (19 mm) locking
screw through the frame lock and into the window sill (FIG. 10).
2. Drive 1/2" screws into the top of the accordion panel frame and
the top rail to securely attach the window air conditioner to the
lower sash. (See FIG. 11/12)
3. To secure the lower sash into place, use the sash lock and a
3/4" screw as shown below (See FIG. 13)
4.For added insulation, cut the supplied insulation foam to the
width of the window. Insert the foam between the window sashes
to prevent air and objects from getting into the room. (See FIG.
14)
Removing the Air Conditioner from the Window
1. Turn the air conditioner off, and disconnect the power cord.
2. Remove the sash seal from between windows, and unscrew
sash lock.
3. Remove the screws installed through the frame and frame lock.
4. Close (slide) the side panels into frame.
5. Keeping a firm grip on air conditioner, raise the sash and
carefully "rock" air conditioner backward to drain any condensate
water in base of unit. Be careful not to spill any remaining water
while lifting unit from window.
6. Store parts WITH the air conditioner in the box.
To Next Page
Loading...
