Emerson Rosemount 1066 - Programming the Transmitter - Basics; General; Changing Startup Settings

Instruction Manual Section 7: Transmitter Programming
LIQ-MAN-1066 April 2017
7.1
7.2
7.2.1
Section 7: Programming the Transmitter – Basics
TABLE 7-1. Measurements and Measurement Units
Transmitter Programming 37
Signal board Available measurements
Measurements units:
pH/ORP – P pH, ORP, Redox pH, mV (ORP, Redox)
Contacting conductivity - C
Conductivity, Resistivity, TDS, Salinity,
NaOH (0-12%), HCl (0-15%), Low H
2
SO
4
,
High H
2
SO
4
, NaCl (0-20%),
Custom Curve
μS/cm, mS/cm, S/cm
% (concentration)
Toroidal conductivity - T
Conductivity, Resistivity, TDS, Salinity,
NaOH (0-12%), HCl (0-15%), Low H
2
SO
4
,
High H
2
SO
4
, NaCl (0-20%),
Custom Curve
μS/cm, mS/cm, S/cm
% (concentration)
Chlorine - CL
Free Chlorine, Total Chlorine, Monochloramine ppm, mg/L
Oxygen - DO
Oxygen (ppm), Trace Oxygen (ppb),
Percent Oxygen in gas
ppm, mg/L, ppb, µg/L % Sat, Partial
Pressure, % Oxygen In Gas, ppm
Oxygen In Gas
Ozone - OZ Ozone ppm, mg/L, ppb, μg/L
General
Typical programming steps include the following listed procedures. Each of these programming
functions are easily and quickly accomplished using the intuitive menu system.
• Changing the measurement type, measurement units and temperature units.
• Choose temperature units and manual or automatic temperature compensation mode
• Configure and assign values to the current outputs
• Set a security code for two levels of security access
• Accessing menu functions using a security code
• Enabling and disabling Hold mode for current outputs
• Resetting all factory defaults, calibration data only, or current output settings only
Changing Startup Settings
Purpose
To change the measurement type, measurement units, or temperature units that were initially
entered in Quick Start, choose the Reset analyzer function or access the Program menus for the
sensor. The following choices for specific measurement type, measurement units are available for
each sensor measurement board.