6
Reference Manual
00809-0200-4802, Rev BA
Section 2: Configuration
May 2013
Configuration
2.2.1 Warnings ( )
2.3 System readiness
If using HART based control or asset management systems, confirm the HART
capability of such systems prior to commissioning and installation. Not all systems are
capable of communicating with HART revision 7 devices.
2.3.1 Confirm correct Device Driver
Verify the latest Device Driver (DD/DTM) is loaded on your systems to ensure proper
communications.
1. Download the latest DD at www.emersonprocess.com.
2. In the Browse by Member dropdown menu, select Rosemount business unit of Emerson
Process Management.
3. Select desired Product
a. Within Table 2-1 on page 7, use the HART Universal Revision and Device Revision
numbers to find the correct Device Driver
Explosions can result in death or serious injury.
Before connecting a 375 Field Communicator in an explosive atmosphere, make sure
the instruments are installed in accordance with intrinsically safe or nonincendive field
wiring practices.
Electrical shock can result in death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads
can cause electrical shock.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: This device may not cause harmful interference this device must accept any
interference received, including interference that may cause undesired operation.
This device must be installed to ensure a minimum antenna separation distance of 20cm
from all persons.
To Next Page
Loading...
