Emerson Rosemount 3101 - Reference Manual

Emerson Rosemount 3101

240 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Reference Manual

00809-0100-4840, Rev CB

February 2015

Rosemount 3101, 3102, and 3105

Ultrasonic Liquid Level Transmitters

Table of Contents

Table of Contents5
Safety Messages13
Manual Overview13
Service Support14
Product Recycling/Disposal14
The Rosemount 3101, 3102, and 310515
- Theory of Operation16
Components of the Transmitter16
System Architecture18
Safety Messages19
Considerations before Installation20
- Safety Considerations20
- Environmental Considerations21
Mechanical Installation22
- Mounting Considerations22
- Consider Liquid Surface Conditions22
- Consider In-Tank Effects23
- Mounting the Transmitter above the Liquid Surface24
- Open Channel Flow Installations (the 3102/3105)26
Electrical Installation28
- Connecting the Cable(S) to the Transmitter28
- Connecting the Cable Wires to the Rosemount 310129
- Connecting the Cable Wires to the Rosemount 310230
- Connecting the Cable Wires to the Rosemount 310531
- Remote Temperature Sensor33
- Wiring to Allow HART Communications33
- Lightning / Surge Protection and Other Loop Devices33
Safety Messages35
Programming the Rosemount 3101, 3102, and 3105 Transmitters36
- Integral Display and Buttons36
- What Happens When Powering up the Transmitter37
- Considerations before Starting the Programming37
Programming the 3101 Using the Integral Display and Buttons38
- Display Units (on the 3101)38
- First Measurements (on the 3101)39
- Setting the Bottom Reference (on the 3101)40
- Setting 4 Ma and 20 Ma Levels (on the 3101)40
- Setting the Output Damping (on the 3101)42
- Selecting the Lost Echo Action (on the 3101)43
- Setting 4 Ma and 20 Ma Levels Using Ranging (on the 3101)44
- Learn about Echoes from False Targets (on the 3101)45
- Do Final Checks46
- What Happens When a Power Failure Occurs46
Programming the 3102 and 3105 Using the Integral Display and Buttons47
- Overview of Programming the 3102 or the 310547
- Selecting the Duty (on the 3102/3105)47
- Selecting the Units of Measurement (on the 3102/3105)48
- Setting the Correct Bottom Reference (on the 3102/3105)50
- Selecting a Profile (on the 3102/3105)51
- Power Factor for the Flow Law (on the 3102/3105)55
- Setting the Scaling Factor (on the 3102/3105)56
- Maximum Level Entry (on the 3102/3105)57
- Maximum Flow Entry (on the 3102/3105)58
- Maximum Contents (Volume) Entry (on the 3102/3105)59
- Setting the 4 Ma Point (on the 3102/3105)60
- Setting the 20 Ma Point (on the 3102/3105)61
- Setting the Output Damping (on the 3102/3105)62
- Selecting the Lost Echo Action (on the 3102/3105)63
- Setting the Relay on and off Points (on the 3102)64
- Setting the 4 and 20 Ma Levels Using Ranging (on the 3102/3105)66
- Do Final Checks67
- What Happens When a Power Failure Occurs67
- Rev CB February68
Safety Messages69
Servicing70
Diagnostics for the 310170
- General Troubleshooting70
- Error Messages70
Diagnostics for the 3102 and the 310571
- General Troubleshooting (on the 3102/3105)71
- Fault and Alarms (on the 3102/3105)71
- Diagnostic Data (on the 3102/3105)72
- Loop Test (on the 3102/3105)73
Engineering Menu for the 3102 and 310574
- Accessing the Engineering Menu (on the 3102/3105)74
- Setting the Threshold (on the 3102/3105)75
- Setting Lost Echo Time (on the 3102/3105)76
- Setting the Dead Band (on the 3102/3105)77
- Setting the Frequency (on the 3102/3105)78
- Setting the Pulse Repetition Frequency (on the 3102/3105)79
- Setting Valid Echo Count (on the 3102/3105)80
- Setting Spike Rejection (on the 3102/3105)81
- Learn about Echoes from False Targets (on the 3102/3105)81
- Setting the Ambient Temperature (on the 3102/3105)83
- Temperature Calibration (on the 3102/3105)84
- Loading Factory Default Values (on the 3102/3105)85
- Changing the Base Units (on the 3102/3105)86
False Echoes under Certain Ambient Operating Conditions87
- (On the 3102/3105)87
Specifications89
- General89
- Measuring Performance89
- A.1 Specifications89
- Display and Configuration90
- Electrical91
- A.1.4 Electrical91
- Materials92
- Mechanical92
- A.1.5 Materials92
- Measuring93
- Environment93
- A.1.7 Measuring93
- Temperature and Pressure Ratings94
- Load Limitations95
- A.1.10 Load Limitations95
A.2 Dimension Drawings96
Dimension Drawings96
Ordering Information99
- Rosemount 3101 Ordering Information99
- A.3 Ordering Information99
- Rosemount 3102 Ordering Information100
- The Rosemount 3105 Level Transmitter101
Spare Parts and Accessories102
- Spare Parts and Accessories for the 3101/3102/3105102
B.1 Manufacturing Location103
Manufacturing Location103
European Union Directive Information103
Non-Hazardous Location Certifications104
- American and Canadian Certifications104
Hazardous Locations Certifications105
- American and Canadian Certifications105
- European Certification105
- International Certifications106
- B.4.3 International Certifications106
B.5 Approval Drawings109
Approval Drawings109
Menus on the 3101114
Menus on the 3102 and the 3105115
D.1 Introduction121
Introduction121
Menus and Parameters121
Introduction125
Menus and Parameters125
Overview of Programming the 3102 and 3105129
- Using a Rosemount 3490 Series Control Unit129
- Using a Field Communicator or AMS Device Manager129
Command Parameters130
- Base Units130
- F.2.1 Base Units130
- Set as Empty132
- F.2.2 Set as Empty132
- Present Depth133
- F.2.3 Present Depth133
- Learn False Echo134
- Auto Tank Map136
- Simulation of PV137
- F.2.6 Simulation of PV137
- Restart Device138
- F.2.7 Restart Device138
- Load Defaults139
- F.2.8 Load Defaults139
- Simulate Current Output140
- Trim 4 Ma / Trim 20 Ma141
Configuration Parameters143
- Message (P000)143
- F.3.1 Message (P000)143
- Tag (P001)144
- F.3.2 Tag (P001)144
- Descriptor (P002)145
- F.3.3 Descriptor (P002)145
- Final Assembly Number (P004)146
- Serial Number (P005)147
- Bottom Reference (P010)148
- Upper Blanking (P023)150
- Lower Blanking (P063)152
- Distance Offset (P060)153
- Level Offset (P069)154
- Tank Shape / Non-Linear Profile (P011)155
- Contents (Volume) Measurement157
- Flow Measurement162
- F.3.13 Flow Measurement162
- Primary Variable Units (P012)165
- Scale Factor / K-Factor (P013)166
- Profile Height / Power Factor (P014)168
- Profile Points 1 to 10 (P030 to P039)170
- Upper Range Value (P015)171
- Lower Range Value (P016)172
- Damping (P020)174
- F.3.20 Damping (P020)174
- Relay 1 Mode (P070) on the Rosemount 3102175
- RL1 PV on Point (P071) on the Rosemount 3102177
- RL1 PV off Point (P072) on the Rosemount 3102178
- Relay 2 Mode (P073) on the Rosemount 3102179
- RL2 PV on Point (P074) on the Rosemount 3102180
- RL2 PV off Point (P075) on the Rosemount 3102181
- Lost Echo Delay (P021)182
- Lost Echo Action (P022)184
- Speed of Sound (P024)186
- Temperature (P025)188
- F.3.30 Temperature (P025)188
- Set Threshold (P026)189
- Transmit Power Control (P040)190
- Pulse Repeat (P041)191
- Echoes Needed (P042)192
- Threshold 1 Time (P043)193
- Threshold 1 Size (P048)194
- Target Pulses (P044)195
- Target Frequency (P045)196
- Spike Rejection (P049)198
- False Echo Data (P081 to P088)199
- Clear False Echoes (P089)199
- F.3.41 Clear False Echoes (P089)200
- Transducer Material (P970)201
- Poll Address (D951)202
- Maximum Temperature (P046)203
- Minimum Temperature (P047)204
- Date (P003)205
- F.3.46 Date (P003)205
Monitoring and Diagnostic Parameters206
- Process Value / Primary Variable (PV) (D900)206
- Level / Secondary Variable (SV) (D901)207
- Distance / Tertiary Variable (TV) (D902)208
- Temperature / Fourth Variable (FV) (D903)209
- Of Current Output (D905)210
- Current Output (D906)210
- F.4.6 Current Output (D906)211
- Distance (D910)212
- F.4.7 Distance (D910)212
- Echo Size (D911)213
- Echo Success (D912)214
- Target Echoes (D913)215
- Speed of Sound (D914)216
- Temperature for Sos Calculation (D915)217
- Frequency (D916)218
- F.4.13 Frequency (D916)218
- Threshold in Use (D917)219
- Pulses in Use (D918)220
- Transmit Power (D919)221
- Model Code (D949)222
- Hardware Rev. (D952)223
- Software Revision (D953)224
- Manufacturer (D960)225
- F.4.20 Manufacturer (D960)225
- Unique Device ID (D961)226
- HART Revision (D962)227
- Transmitter Specific Command Revision (D963)228
- Preambles (D964)229
- F.4.24 Preambles (D964)229
- Transmitter Flags (D965)230
- Primary Variable Trend231
- Temperature Trend231
- Distance and Echo Size Trend232

Other manuals for Emerson Rosemount 3101

Quick Start Guide48 pages

Related product manuals

Preview: Emerson Rosemount 3100 Series

Emerson Rosemount 3100 Series

Preview: Emerson Rosemount 3152

Emerson Rosemount 3152

Preview: Emerson Rosemount 3144P

Emerson Rosemount 3144P

Preview: Emerson Rosemount 3051

Emerson Rosemount 3051

Preview: Emerson Rosemount 3095

Emerson Rosemount 3095

Emerson Rosemount 3051C

Preview: Emerson Rosemount 3051D

Emerson Rosemount 3051D

Preview: Emerson Rosemount 3300 Series

Emerson Rosemount 3300 Series

Preview: Emerson Rosemount 3051S Series

Emerson Rosemount 3051S Series

Rosemount 300S WirelessHART

Preview: Rosemount 3051S MultiVariable

Rosemount 3051S MultiVariable

Rosemount MultiVariable 3051S Series