Emerson Rosemount 5301 - Page 27

Product Data Sheet
00813-0100-4530, Rev DA
December 2010
27
Rosemount 5300 Series
TABLE 6. Alloy C-276: conditions used for flange strength calculations
Bolting material Gasket Flange material Hub material
HP/HTHP/C
ASME /
ANSI
UNS N10276
Soft (1a) with min.
Thickness 1.6 mm
Spiral wound gasket with
nonmetallic filler (1b)
SB462 Gr. N10276
(solution annealed
condition) or SB575 Gr.
N10276 (solution
annealed condition)
SB574 Gr. N10276
EN, JIS
Soft (EN 1514-1) with
min. Thickness 1.6 mm
Spiral wound gasket with
nonmetallic filler (EN
1514-2)
Maximum Upper Product Thickness for the Flexible Twin
Lead Probe in ft (m)
Lower product
dielectric constant
Maximum upper product thickness
Upper product dielectric constant
1
35
7
9
11
0
16 (5)
33 (10)
49 (15)
66 (20)
82 (25)
98 (30)
115 (35)
80
40
20
10
Maximum Upper Product Thickness for the Flexible Single
Lead Probe in ft (m)
Maximum upper product thickness
Upper product dielectric constant
Lower product
dielectric constant