Emerson Rosemount 8600 Series - Verification and Product Compliance; Verifying Device Configuration

Quick Start Guide
13
September 2016
1. Verify the cover jam screw is completely threaded into the housing.
2. Install the transmitter housing cover and verify that the cover is tight against
the housing.
3. Using an M4 hex wrench, loosen the jam screw until it contacts the
transmitter cover.
4. Turn the jam screw an additional
1
/2 turn counterclockwise to secure the
cover.
Note
Application of excessive torque may strip the threads.
5. Verify that the cover cannot be removed.
6.0 Verify configuration
Before operating the Rosemount 8600D in an installation, you should review the
configuration data to ensure that it reflects the current application. In most cases,
all of these variables are pre-configured at the factory. Configuration may be
required if your flowmeter is not configured or if the configuration variables need
revision.
Rosemount recommends the following variables are reviewed before startup for
a HART configuration:
 Tag
 Transmitter Mode
 Process Fluid
 Reference K-Factor
 Flange Type
 Mating Pipe ID
 PV Units
 PV Damping
 Process Temperature Damping
 Fixed Process Temperature
 Auto Adjust Filter
 LCD Display Configuration (For units with a display only)
 Density Ratio (For Standard or Normal flow units only)
 Process Density and Density Units (For mass flow units only)
 Variable Mapping
 Range Values
 Pulse Output Configuration (For units with a pulse output only)