22
Reference Manual
00809-0100-4860, Rev BC
Section 2: Installation
January 2013
Installation
Mounting
Mount the meter body in the process flow line as described earlier in this section. Mount the
bracket and electronics housing in the desired location. The housing can be repositioned on the
bracket to facilitate field wiring and conduit routing.
Cable connections
Refer to Figure 2-15 and the following instructions to connect the loose end of the coaxial cable
to the electronics housing. (See “Remote electronics procedure” on page 83 if connecting/dis-
connecting the meter adapter to the meter body.)
Figure 2-15. Remote Electronics Installation
NOTE
Consult factory for SST installation
Ground
Connection
Housing Adapter
Housing Adapter Screws
Electronics Housing
Coaxial
Cable Nut
Housing
Base Screw
1
/2 NPT Conduit Adapter or Cable Gland
(Supplied by Customer)
Coaxial Cable
Meter Adapter
Union
Washer
Sensor Cable Nut
Meter Body
Nut
Bracket
½ NPT Conduit Adapter or Cable
Gland (Supplied by Customer)
Get other manuals https://www.bkmanuals.com
To Next Page
Loading...
