78
Reference Manual
00809-0100-4860, Rev BC
Section 5: Troubleshooting
January 2013
Troubleshooting
3. If the meter has the LCD indicator option, loosen the two screws. Remove the LCD and
the connector from the electronics board.
4. Loosen the three captive screws that anchor the electronics.
5. Use pliers or a flathead screwdriver to carefully remove the sensor cable clip from the
electronics.
6. Remove thermocouple if MTA option installed.
7. Use the handle molded into the black plastic cover to slowly pull the electronics boards
out of the housing.
Figure 5-7. Electronics Boards Assembly
Get other manuals https://www.bkmanuals.com
To Next Page
Loading...
