Quick Start Guide
29
August 2015
7.4 Parity (register 116)
Used to configure error-checking methodology for the data.
7.5 Stop bits (register 117)
Sets the last bit of the data packet.
Step 8: Basic configuration
Once the magnetic flowmeter is installed and power has been supplied, the
transmitter must be configured through the basic setup. These parameters can
be configured through either a local operator interface or a Modbus
communication tool. Configuration settings are saved in nonvolatile memory
within the transmitter. A complete map of the Modbus registries and descriptions
of the more advanced functions is available in Reference Manual
00809-0400-4444.
Basic setup
8.1 Tag (Registers 68–71)
Tag is the quickest and shortest way of identifying and distinguishing between
transmitters. Transmitters can be tagged according to the requirements of your
application. The tag may be up to eight characters long.
Register value Parity
0No parity
1Odd
2Even (default)
Register value Stop bits
11 bit (default)
22 bits
To Next Page
Loading...
