SWITCHING SYSTEM MODE
Press the “Mode” button to switch between all available system mode settings.
When the Mode is “Off” the thermostat will not bring on your heating or cooling systems.
FAN MODE
If you want to circulate the indoor blower, you can switch Fan to “On.” Turn the Fan back
to “Auto” when you want the thermostat to control your indoor blower as necessary. Leaving
the Fan in “On” will run your blower continuously.
HOLDING ONE TEMPERATURE
If you want to hold one temperature, turn Schedule “Off.” Then, adjust the set point using
the up and down arrow buttons. The thermostat will hold this temperature, in the set Mode,
until you turn Schedule back “On” or until you adjust the set point again using the up and
down arrow buttons.
TEMPORARY HOLD
When your schedule is set to “On,” your Sensi thermostat controls your home based on
the time and temperature settings in the current schedule. To temporarily change your
temperature use the up and down arrows in the app or on the thermostat. Your Sensi
thermostat will display “Temporarily Set To” on the thermostat and will hold your new
temperature until the next scheduled set point with a minimum hold time of two hours.
TURN WI-FI OFF
If connecting to Wi-Fi is not an option, you can turn off Wi-Fi on the
thermostat and manually set a time and a schedule from the wall unit.
To turn off Wi-Fi:
1 Press “Menu”.
2 Press “Next” five times to go to the “Wireless (Setup)” screen.
“On” should be flashing at the top.
3 Use the up and down arrow buttons to change it to “Off”.
4 Press “Exit”.
Basic Functionality
Sensi
TM
Wi-Fi Programmable Thermostat | MANUAL OPERATION 4
4
1 2 3
To Next Page
Loading...
Need help?
General
