Europe, Middle East, and Africa Only
INSTALLATION (continued)
Ensure that the data found on the regulator plate are •
compatible with usage requirements.
Ensure that the regulator is mounted in accordance with •
the direction of ow indicated by the arrow.
Make the connections as indicated in Figure 7.•
!
WARNING
service a regulator.
and applicable codes and regulations.
servicing is required.
regulator is over pressured or is installed
pressure-relieving or pressure-limiting
conditions from exceeding limits.
regulator could result in personal injury and
regulator in a safe location.
limitations and if pilot set-up or possible
protected equipment.
All means for venting must be provided in
All means for draining must be provided for
any equipment installed before regulators and
product is used:
isolation to avoid any corrosion;
for pressure containing parts.
piping and bolting practices.
Installation must be performed avoiding to
suitable joint means according to equipment
dimensions and service conditions.
any protection suitable for assembly’s
Note
unobstructed at all times.
STARTUP
The regulator and possible built-in slam-shut device is
factory set at approximately the midpoint of the spring range
or the pressure requested, so an initial adjustment may be
required to obtain desired results.
With proper installation completed and relief valves
properly adjusted, slowly open the upstream and
downstream line valves.
To Next Page
Loading...
