Emerson Unidrive M100 - Menu Navigation and Parameter Management

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization NV Media Card
Advanced
parameters
Diagnostics UL Listing
Unidrive M100 / M101 Control User Guide 17
Issue Number: 1
Figure 5-3 Display modes
Show previous or next
parameter
or
- Press and release to go to next or
previous parameter. Parameter flashes
briefly then goes back to View.
- Holding or scrolls through each
parameter within the menu.
Press and release.
Show last slot / menu / param
selected
Press and release to
edit Parameter
Menu select
Press or to select menu
Edited digits flash
Press and
release to view
Parameter select
Press or to select parameter.
Edited digits flash
Press and release
to edit
- Press and release to accept
new value to be set.
- Reset drive if required.
- Execute action if required.
Press and
release to
discard new
value and return
to original value
Press and release to
edit Menu
Press and release to
edit Parameter
View
Edit
Press or to select value
- Edited digit flashes
- Holding or increases or decreases value.
- Modified value has a direct effect on the drive
except routing parameters and special parameters.
- New value can be validated or discarded.
- Holding + or edit the next or previous
digit.
Press and release to
go back to status
Timeout
240 s or hold
Press and release to
edit Menu
Slot select
(Only if option installed)
or
Press or to select _ or 1
Edited digit flashes
Press and release to
edit Slot
Parameter format s.mm.ppp
s: _ or 0: for drive. If drive is
selected then hide first digit and
show only menu and parameter.
1: for option
mm: menu number (0 to 99)
ppp: parameter number (0 to 999)
Status
If Drive Status (Pr 10.101) = 4 (Run)
Show value only
If Drive Status (Pr 10.101) <> 4
Show status only
Go to Status if no
option installed
- Holding and together sets value to
zero.
Holding
or timeout will discard
new value and return
to original value.
or
or