Emerson Unidrive M700 - Page 69

SI-Ethernet User Guide 69
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
This parameter is used to set the link number (1 to 255) for the Rx2 link.
This parameter sets the destination parameter for the Rx2 link.
This is used to set the number of contiguous parameters for the Rx2 link.
This parameter specifies the type of transmission for the Rx2 link.
S.10.051 Rx2 Link Number
Minimum 0 Maximum 255
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.052 Rx2 Destination Parameter
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
0
(Display: 0.00.000)
Units
Type 32 Bit User Save Update Rate Read on reset
Display Format Slot Menu Param Decimal Places 0
Coding RW, PT, BU
S.10.053 Rx2 Parameter Count
Minimum 0 Maximum 10
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.054 Rx2 Source Type
Minimum 0 Maximum 5
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, TE, BU
Value Text Description
0 Direct Link is unicast or broadcast
1 Multicast1 Link is multicast to the IP address
2 Multicast2 Link is multicast to the IP address
3 Multicast3 Link is multicast to the IP address
4 Multicast4 Link is multicast to the IP address
5 Local Link will receive from local transmit link