11
4.2 Connect wires to corresponding terminal blocks
Match each labeled wire to it’s corresponding terminal on the mounted thermostat base. Insert each labeled wire into
the hole of it’s matching terminal, and using the screwdriver, tighten the screw on the terminal block securely.
4.3 Set switch and advanced wiring
Take care when securing and routing wires so they do not short to adjacent terminals or rear of thermostat. Personal injury and/or property damage
may occur.
Electric / Gas
switch
If you have either a gas or oil furnace, set the switch to GAS.
If you have an electric furnace, set the switch to ELEC.
To Next Page
Loading...
