Emerson Easyheat Warm Tiles User Manual

FGS Thermostat Operating & Installation Instructions
PACKAGE CONTENTS
1 Thermostat
2 #6-32 x 1” screws
1 Sensor / Wire Assembly — 10’ long
4 Wire Connectors
Electrical installation must be in accordance with all applicable national electrical codes (NEC, CEC) as well
as local electrical and building codes, regulations and inspection procedures. Electrical inspection of the
installation may be required before, during, and after installation. Check with your local electrical inspection
department before beginning installation. This device is a Class A Ground Fault Circuit Interrupter as required
by some electrical codes for floor warming installations.
© 2016 EASYHEAT, Inc
www.warmtiles.com
14180-001 Rev. 0

Emerson Easyheat Warm Tiles Specifications

General

Maximum Load	15A
Floor Sensor	Yes
Mounting	Wall-mounted
Warranty	3 years
Voltage	120/240V
Programmable	7-day programmable
Display	Backlit LCD

Summary

Thermostat Control Buttons

Primary Control Buttons

On/Off, Event/Program, Next/Save, Back/Cancel functions.

Installation Guide

New Construction Rough-In & Thermostat Mounting

Steps for initial wiring and mounting the thermostat unit.

Advanced Thermostat Controls

Hold, Settings, GFCI, Navigation Buttons

Advanced controls for temp, settings, GFCI, and navigation.

Understanding the LCD Display

Time, Schedule, and Status Indicators

Explains display of time, modes, sensor, and temperature.

Quick Start Operation

Default Program Schedule

Outlines pre-programmed weekday/weekend schedules.

System Settings Configuration

Time, Day, Units, Backlight, Floor Type

Setting time, day, units, backlight, and floor type.

Manual Temperature Adjustments

Temporary and Permanent Hold

Setting temporary or permanent temperature holds.

Customizing Heating Schedules

5/2 Day and 7 Day Schedule Customization

Tailoring heating schedules for different days.

GFCI Protection and Testing

GFCI Operation, Faults, and Testing

GFCI functionality, fault detection, and monthly testing.

Factory Reset Procedure

Resetting Program Schedules

Restores default 5/2 Day & 7 Day programs.

Troubleshooting Common Issues

Display, Power, GFCI, and Temperature Problems

Solutions for common operational issues.

Warranty and Liability Information

Warranty Terms, Exclusions, and Support

Details on product warranty, exclusions, and contact.