EMKO ESM Series - Alarm System Configuration; Alarm-2, Protection, and Alarm Types

ENGLISH
: Protection Menu Parameter
: Alarm Type selection. (Default: )
: Alarm Set High Limit parameter. It can be adjusted from Alarm Set Low Limit to
:
to Alarm Set High Limit. (Default: 0)
Alarm Set Low Limit parameter. It can be adjusted from Operation Scale minimum
: Alarm on Delay Time. It can be adjusted from 0 to 9999 seconds. (Default: 0)
: Alarm off Delay Time. It can be adjusted from 0 to 9998 seconds. If it is higher than
NOTE: Alarm-2 parameters(AHS2 , AtS2 , Alo2 ,AuP2 , Aon2 , AoF2 )
are active,if Cout parameter is set as SSR.
:
9999. If is 0, password screen is not observed. If is different from 0 and user
enters to the menu pages without entering the password, all the menus can be observed
except protection menu . But device does not allow to do any changes in
parameters. (Default value is 0)
Password for accessing to the programming section. It can be adjusted from 0 to
Alarm Types
Alarm
Output
Process Low
Alarm
ON
OFF
Process Value
Process High
Alarm
ON
OFF
Alarm
Output
Process Value
11
: Alarm Hysteresis value. It can be adjusted from %0 ile %50 of the Scale
( - ). (Default: 0)
Operation Scale maximum. (Default: 500)
9998, is seen on the screen and Alarm Latching Output is selected. (Default: 0)