EMKO ESM-3710 - User Manual

ESM-3710 77x35 DIN Size Temperature Controller
- 3 Digits Display
- NTC Input or,
PTC Input or,
J type thermocouple Input or,
K type thermocouple Input or,
2-Wire PT 100 Input or,
2-Wire PT 1000 Input (It must be determined in order)
- ON/OFF temperature control
- Selectable heating or cooling function
- Selection of operation with hysteresis
- Adjustable temperature offset
- Set value low limit and set value high limit boundaries
- Relay or SSR driver output
- Operation selection of compressor operates continuously, stops
or operates periodically in case of probe defect
- Compressor protection delays
- Password protection for programming mode
ESM-3710 77 x 35 DIN Size
Digital, ON / OFF Temperature Controller
Instruction Manual. ENG ESM-3710 02 V08 07/13

Summary

Installation

Panel Mounting

Electrical Wiring

Terminal Layout and Device Label

Electrical Wiring Diagram

Presents the schematic diagram for the electrical wiring of the ESM-3710.

Supply Voltage Input Connection

Guides on connecting the power supply to the unit.

TC, PTC and NTC Sensor Connections

Details connections for TC, PTC, and NTC type temperature sensors.

PT-100 and PT-1000 Sensor Connections

Details connections for PT-100 and PT-1000 resistance temperature detectors.

Output Connections

Explains how to connect the Relay and SSR Driver outputs.

Front Panel and Menu Access

Changing and Saving Set Value

Step-by-step guide to changing and saving the desired temperature set point.

Program Parameters Overview

Overview of key parameters like hysteresis, limits, and delays.

Programming Mode Navigation

Entering and Managing Parameters

Failure Messages and Specifications

Failure Messages

Technical Specifications

EMKO ESM-3710 Specifications