EMM Labs DA2i - Page 14

© 2024 EMM Labs, All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
013
Operation
DA2i STEREO D/A CONVERTER OWNER’S MANUAL
Operation
Menu Functions
Brightness : e “BRIGHTNESS” function allows the end user to set the brightness
of the display. Using the “CHANGE” touch button, brightness can
be set between “High” and “Low”. ere is also an option to turn the
display o using the “DISP. OFF” option. In display o mode, the
center touch button indicator will still be lit showing that the DA2i is
still on
Screen Saver : e screen saver engages aer 2 minutes of inactivity. It dims the
screen for 3 seconds, then turns the screen o. Engaging the remote or
touch buttons, returns screen brightness to its’ previous state. It is
disabled when the display o mode is engaged. is function stops
the OLED display from burn-in issues when the DA2i is le on for a
prolonged periods of time. Press the “CHANGE” touch button to
enable or disable the screen saver
Factory Reset : Pressing the “RESET” touch button resets all settings and user saved
presets of the DA2i back to factory default. When “RESET” is pressed,
an additional prompt will request for reset conrmation, prior to
execution. e DA2i’s “HIGH” and “LOW” gain setting is also set here
Reset Network : Resets the network connection. Please read and follow the prompt
carefully. DO NOT turn o the DA2i (standby button or main power
switch) while the network system is resetting the network connection.
Doing so may damage the network interface
Screen brightness
Is High
CHANGE
EXIT DISP.OFF
BRIGHTNESS
Screen Saver
Enabled
CHANGE
EXIT
SCREEN SAVER
Reset
User Settings
DAC Gain is HIGH
RESET
EXIT LOW HIGH
FACTORY RESET
Reset
Network Interface
RESET
EXIT
RESET NETWORK