Emmaljunga UniQ 310 - Assembly of pram body; Pram Body Assembly Steps

This section applies to following products:
Duo Combi Mondial 3-in-1, Edge 3-in-1
1
1
2
3
6
4
5
6
8
7
9
2
1
3
4
5
106
Manual Duo Combi UniQ 310 v 1.6
Assembly of pram body
Assembly of pram body
• Remove plastic covers from mattress, apron, Hi Pro, interior lining
and discard. Slide the two metal support brackets (1) onto the base
(2) of the pram body. The base is made of plastic.
WARNING
• Choking Hazard. Keep plastic covers away from children.
• Make sure the two metal support brackets are securely locked.
The t will be tight to ensure stability and safety.
• Place the Hi Pro (3) towards the side of the Pram body's head-end
for added protection.
• Fold the interior lining around the rim of the pram body. Fasten the
velcro (5) of the head-end of the pram body (4). Make sure the
trimmed hole (6) on each side of the lining is threaded around the
plastic holders (one on each side of the pram body).
• Turn over the backrest (7) to its layback position.
• Insert the mattress (8).
WARNING
• The depth of the top of the mattress or other bed accessories, to
the top of the side of the carrycot, should not be less than 150 mm
when the mattress is in position. Only use mattresses with a thick-
ness of maximum 45 mm
• The exclusive mattress consists of a combination of bre lling
and polyeter lling. Make sure that you place the mattress with the
rmer polyeter lling facing downwards in the carrycot.