Emmaljunga UniQ 310 - How to use the UniQ 310 chassis; Adjusting Suspension, Brake, and Folding

1
2
2
1
4
3
5
3
4
111
Manual Duo Combi UniQ 310 v 1.6
How to use the UniQ 310 chassis
WARNING
• Make sure children are clear of any moving parts if you adjust the
stroller, otherwise they may be injured.
Folding of the pram
• Remove the carrycot or seat unit part of the chassis.
• Fold the chassis by rst adjusting the handle height into a slightly
downwards position. Press in the release buttons (3) on each side,
whilst at the same time pulling the two chassis locks (4, one on
each side) upwards.
WARNING
To avoid injuries make sure that children are kept away when folding
and unfolding the chassis.
Engaging the parking brake
• The parking brake (2) is for use when you are near the pram and/or
when the child is not in the pram.
• Engage the parking device by pushing down the brake pedal with
your foot.
• Disengage the parking brake by pulling up the brake pedal with
your foot.
• Whilst holding the chassis locks up fold the handle forward.
• Fold the handle forward.
How to adjust the suspension.
When the pram has been used for a while you will be able to adjust
the rmness of the suspension.
• Remove your child from the pram before adjusting the suspension.
• Adjust the suspension by pushing the button (1) up or down. There
is a button on each side of the chassis. If the button is pushed
upwards the suspension is tightened and if it is pushed down the
action is reversed. To do this, adjust the springs on each side of the
pram. One side adjusts the suspension on the front wheels and the
other adjusts the suspension on the rear wheels.
• Repeat on both sides of the chassis and check that the button is in
the same, locked position on both sides.
WARNING
• The suspension adjusters must be in the same position on both
sides of the chassis to avoid uneven strain and possible damage to
the chassis.
This section applies to UniQ 310 chassis
English