1
7
2
4
5
2
6
3
1
110
Manual Duo Combi UniQ 310 v 1.6
Assembly of the UniQ 310 chassis
Assembly of the wheels
• Remove the plastic protectors (1) from the axles. Save for future
use.
IMPORTANT
• Axles may be covered with axle grease which can leave stains on
fabric.
WARNING
• Choking hazard - keep the plastic protectors away from children.
• Make sure that the parking device is not engaged. Press in the
release button (2) on wheel hub (1) and slide the wheel all the way
on to the axle. Release the button and pull the wheel toward you
until you hear an audible click.
WARNING
• Pull the wheel towards you to ensure that the wheel is securely at-
tached to the axle.
Repeat the same procedure on each of the four wheels.
WARNING
• Make sure that children are kept away from moving parts when
assembling the pram, otherwise they might be at risk of injury.
Assembly of the chassis
• Engage the parking device by pressing the parking brake pedal
down with your foot (3).
• Unfold the chassis by raising the handlebar (4) whilst holding down
the chassis side bar (5).
• The safety button (6) will engage automatically to prevent acciden-
tal folding.
WARNING
• The chassis locks (7) must click into the locked position.
• Always check that the main locking devices (7) are engaged
correctly before using your pram. It is dangerous to use your pram
when the locks are not in their correct position.
This section applies to UniQ 310 chassis
To Next Page
Loading...
