Emmaljunga UniQ 310 - How to use the pram body; Fitting, Detaching, and Adjusting Features

This section applies to following products:
Duo Combi Mondial 3-in-1, Edge 3-in-1
6
1
3
4
5
2
2
1
3
4
5
108
Manual Duo Combi UniQ 310 v 1.6
How to use the pram body
Adjusting the Backrest
• Raise the backrest (3), push the steel frame (4) so that it rests
against the metal support bars.
Fitting the pram body on the chassis
• The brake should be engaged
• Push the Easy Fix lock (1) until it “clicks into” place on both sides.
WARNING
• Check before use that the pram body is securely in place
Detaching the pram body from the chassis
• The vehicle brake should be engaged
• Push the Easy Fix grips (2) on both sides of the carrycot and re-
lease the carry-cot part straight up from the chassis.
IMPORTANT
• You must release the carrycot part before you fold the chassis
WARNING
• Never attach/detach pram body with a child inside.
Adjusting the Hood
• Adjust the hood by gently pulling the front of the hood back and
forth to the desired position.
Do not adjust the hood with the apron attached
IMPORTANT
• Never carry the pram body by the hood
• Never carry the pram body when it is assembled onto the chassis
Adjusting the ventilation system
• Adjust the airow to maximum by pulling the lever (5) outwards
away from the pram body.
• Push the lever inwards to close the ventilation holes.
IMPORTANT
• On the bottom of the pram body there are xing points for a
separate harness that complies with BS 6684.
Cradle function
• The pram body can be used as a cradle (6) on indoor, horizontal
and even surfaces.
WARNING
• Never place pram body near stairs, on top of tables or in other
areas where it might fall down.
• Never use pram body as a cradle outdoors or on uneven surfaces.
• Never use the pram body as a permanent bed for your child.