emmeti CTUP - Setting a Timing

English
- 47 -
Chronothermostat with Humidistat User Manual
To activate timing it is necessary to press
the
“ " key
The display will flash "00’"
indicating the
timing value (00 ‘ = function disabled).
Pressing the key
" " it is possible to
increase the value. For timings up to 24
hours the increase is of 15 minutes at a time,
over the 24 hours the increase is of 1 hour
at a time.
Timed deactivation
If in off status you set a timing, such off status will be maintained until the end of
the timing; operation will then switch to the one active before deactivation. If, during
timing, the system is activated, the timing ends.
In all cases, the timing condition is signalled by the symbol "
".
Setting a timing
Once the value has been set, press
" " to
confirm or wait 45 seconds.
Note. In case time is modified during
timing, it will not be updated.