Need help?Do you have a question about the Emotiva basX A-300 and is the answer not in the manual?
General| Type | Stereo Power Amplifier |
|---|---|
| Channels | 2 |
| Gain | 29 dB |
| Damping Factor | > 500 |
| Power Output (8 Ohms) | 150 Watts per channel |
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 100 dB |
| Input Sensitivity | 1.2V for full rated power |
| Power Consumption | 600 Watts |
| Dimensions (W x H x D) | 17 x 3.5 x 14.5 inches |
| Power Output (4 Ohms) | 300 Watts RMS per channel; 20 Hz – 20 kHz; THD < 0.1%; into 4 Ohms |
Controls power state; halo ring indicates Standby (amber) or On (blue).
Shows status LEDs for amplifier channels; can be disabled.
Accepts 12 VDC trigger for On/Off; provides 12 VDC output to control other devices.
Independent unbalanced RCA inputs for each amplifier channel.
Details power output per channel for A-300, A-500, and A-700 models into 8 Ohms.
Addresses issues with no power or illumination, suggesting checks for AC power.
Troubleshoots non-lit status LEDs, directing user to rear panel switch.
Guides on checking sources and speaker connections when no fault is indicated.
Diagnoses fault conditions indicated by flashing red LEDs, suggesting power cycle and checks.
Helps resolve issues with trigger activation, recommending checks of trigger cables and settings.
Defines what defects in materials and workmanship are covered by the warranty.
Specifies the duration of the warranty period for the product and accessories.
To Next Page
