Need help?Do you have a question about the Emotiva RPA-1 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Sensitivity | 1.5 V |
| Damping Factor | > 500 |
| Type | Power Amplifier |
| Frequency Response | 20 Hz to 20 kHz +/- 0.1 dB |
General safety guidelines, including water, ventilation, and heat.
Precautions against electric shock and importance of proper grounding.
NEC guidelines for grounding CATV systems for installers.
Essential safety measures for grounding outdoor antennas.
Acknowledges the purchase and introduces the product's value.
Highlights the advanced technologies and design philosophy.
Instructions for checking contents and keeping packaging.
Guidance on documenting unit information for warranty.
Details on power switch, dimming, and status LED indicators.
Details on RCA/XLR inputs and speaker binding posts.
Covers power receptacle, fuse, trigger inputs, and turn-on selectors.
Guidance on electrical needs and circuit sharing.
Recommendations for unit placement, ventilation, and heat.
Advice on cable routing and speaker connection methods.
Best practices for making connections for optimal audio performance.
Diagrams showing preamp connection via XLR and RCA inputs.
Diagram for single connection to two loudspeakers (left/right channels).
Details on using two RPA-1 amplifiers for bi-amping speaker drivers.
Describes series connection of speakers and impedance calculation.
Describes parallel connection of speakers and impedance calculation.
Imperative notes on using identical speakers and impedance limits.
General advice on speaker placement importance and room interaction.
Directing sound to ear level and creating an imaginary triangle.
Specific recommendations for positioning left and right front speakers.
Guidance on optimal placement for subwoofers in a 2.1 system.
Lists potential causes and solutions for lack of audio output.
Troubleshooting steps for amplifier shutdown or breaker tripping.
Advice for diagnosing and fixing poor bass output.
Solutions for audible thumps during amplifier power cycling.
Steps to identify and eliminate ground loop hum.
Addresses potential noise sources from AC lines or component proximity.
Explains blinking/solid red LEDs for clipping and fault conditions.
Guidance for complex system issues, recommending dealer contact.
Specifies power output per channel and frequency response.
Details THD, S/N ratio, impedance, sensitivity, and trigger input.
Covers power requirements, ventilation, weight, and dimensions.
Copyright notice and statement on product specification changes.
Outlines warranty period, exclusions, and conditions.
Instructions for obtaining service and RMA numbers.
To Next Page
