EMPHASER EA4100-500 - Technical Specifications; Power Output Ratings; Performance Metrics; Filtering, Fuses, and Dimensions

30
8. TECHNICAL SPECIFICATIONS
EA4100-500 6-Channel Amplifier
Rated Power Output (RMS)
At 4 Ohms load / 13.8V (THD<=0.1%)
Channels 1/2-CH and 3/4-CH 82Wx4 all channels driven simultaneously
Channels 5/6-CH 225Wx2 all channels driven simultaneously
Rated Power Output (RMS)
At 4 Ohms load / 13.8V (THD<=1%)
Channels 1/2-CH and 3/4-CH 90Wx4 all channels driven simultaneously
Channels 5/6-CH 241Wx2 all channels driven simultaneously
Rated Power Output (RMS)
At 2 Ohms load / 13.8V (THD<=0.1%)
Channels 1/2-CH and 3/4-CH 135Wx4 all channels driven simultaneously
Channels 5/6-CH 313Wx2 all channels driven simultaneously
Rated Power Output (RMS)
At 2 Ohms load / 13.8V (THD<=1%)
Channels 1/2-CH and 3/4-CH 144Wx4 all channels driven simultaneously
Channels 5/6-CH 329Wx2 all channels driven simultaneously
Rated Power Output (RMS)
At 4 Ohms load / 13.8V (THD<=0.1%)
Channels 1/2-CH and 3/4-CH bridged 270Wx2 all channels driven simultaneously
Channels 5/6-CH bridged 620Wx1 all channels driven simultaneously
Damping Factor
All Channels stereo @ 4Ohms/100Hz > 200
Signal-to-Noise Ratio
(All channels) > 93 dB
Frequency Response
(all channels, frequency filtering
controls deactivated) 10Hz - 50 kHz (+0 dB / - 1 dB)
Channel Separation > 60 dB
(all channels)
Input Sensitivity
(all channels) 200 mV - 9.4V
Integrated Active Filtering
Slope Rates 12 dB /octave
Cross-Over Frequency
High Pass continuously variable 10 - 400 Hz
Low Pass continuously variable 40 - 400Hz
Fuse 2 x 80 A
Dimensions (W x H x D) 610 x 71 x 277 mm
EA 6-CH Manual 12.03.2002 13:32 Uhr Seite 30