92
EN
ZH
VERSION 1
VERSION 2
阀组装
Valve assembly
If the valve is damaged or worn out, it must be replaced immediately.
To replace the powder chamber valve:
• Do not turn the powder chamber upside down.
• Unscrew the valve assembly under the powder chamber with a coin, unclip the cap and extract
the valve.
• Place the new valve in the correct position on the support and screw the assembly under the pow-
der chamber.
If an O-ring is damaged or worn out, it must be replaced immediately.
Valve assembly
FB-581_CN_rev_B_AIR-FLOW Master Piezon.indd 92 13/09/2018 16:20:15
To Next Page
Loading...
